HP StorageWorks XP48 Disk Array - Manual (Page 119)

Managing File Systems 119
To select the volume (step 1 of 2 in Expand File System):
1. Depending on the contents you want to display, set the following item on the Expand File System – Step
1 of 2 dialog box (refer to
Figure 7-6 ):
Displayed Volumes: Select the volume display range.
• Usable Volumes: Of the volumes that the host can use with LUN security, a list is displayed of the
usable volumes and volumes usable under certain conditions.
• All Volumes: A list is displayed of all volumes that are set to use LUN security with that host.
A maximum of 10 volumes are displayed at a time. When there are 11 or more volumes to be displayed,
the eleventh and subsequent volumes can be viewed by selecting another range in RANGE:
A maximum of 16,384 volumes can be displayed by switching pages.
2. Select the desired volume from the displayed volume list. Select the radio button of the volume to be used
to expand the file system by Volume ID.
NOTE: From Subsystem, select the storage subsystem from a pull-down list to display a dialog box
with only the volumes from the selected subsystem.
Click the Show Data Path button to display a dialog box with the following path information: HBA WWN,
storage subsystem port, and storage subsystem volume.
3. If you select a volume that is only usable under certain conditions, a dialog box is displayed that indicates
the reason for those conditions and asks you to confirm that you want to select this volume.
CAUTION: If you use a volume that is only usable under certain conditions, some data may be lost or
other hosts may lose the access privileges to the volume. Before using such a volume, check the
warning message and make sure that there are no problems.
4. If there are no problems, select the I have checked the above warning, and still want to proceed checkbox
located below the warning message.
CAUTION: If you click the OK button without selecting the checkbox, an error occurs.
5. Click the Next button. The Expand File System - Step 2 of 2 dialog box is displayed. The next section
shows this dialog box and describes the settings to be specified at this step.
7-5-2 Confirming the Settings
In this step, confirm your setting selections. Figure 7-7 shows the Expand File System dialog box for confirming
your settings (step 2 of 2).
Figure 7-7 Expand File System - Step 2 of 2 (Summary of Changes)