3-2 setting parameters, 3-3 confirming the settings, Selecting a volume – HP StorageWorks XP48 Disk Array User Manual
Page 114: See section
Managing File Systems 114
3.
If you select a volume that is usable under certain conditions, a dialog box is displayed that indicates the
conditions and asks you to confirm that you are sure you want to select this volume.
CAUTION:
If you use a volume usable under certain conditions, some data may be lost or other hosts
may lose the access privileges to the volume. Before using such a volume, check the warning message
and make sure that there are no problems.
4.
If there are no problems, select the I have checked the above warning, and still want to proceed checkbox
located below the warning message.
CAUTION:
If you click the OK button without selecting the checkbox, an error occurs.
5.
Click the Next button. The Add File System - Step 2 of 3 dialog box is displayed. The next section shows
this dialog box and describes the settings to be specified at this step.
7-3-2 Setting Parameters
In this step, set the parameters to be used in creation of the file system.
shows the Add File System
dialog box for setting the parameters (step 2 of 3).
Figure 7-3
Add File System - Step 2 of 3 (Specify Parameters)
To set the parameters (step 2 of 3 in Add File System):
1.
Set the following items on the Add File System – Step 2 of 3 dialog box (refer to
):
File System: Set the following file system items:
•
Type: Select the file system type from the pull-down list.
•
Mount Point: Enter the mount point. For details on restrictions on the value to be entered, see Help
for the windows.
Volume Manager: Set the following volume manager item:
•
Name: Select the volume manager name from the pull-down list.
2.
After completing the settings, click the Next button. The Add File System - Step 3 of 3 dialog box is
displayed. The next section shows this dialog box and describes the settings to be specified at this step.
7-3-3 Confirming the Settings
In this step, confirm the contents of your settings.
shows the Add File System dialog box for
confirming the settings (step 3 of 3).