5-1 selecting a volume, Expanding a file system – HP StorageWorks XP48 Disk Array User Manual
Page 118
Managing File Systems 118
•
The volume is being used as an S-VOL or SP-VOL for Business Copy XP.
•
The volume is being used as a V-VOL or POOL for Snapshot XP.
•
The Auto Lun XP attribute has been set for the volume.
•
The volume is being used as an on-demand device.
•
The Read/Write permissions have not been set in the LUN Security XP Extension function.
•
The volume emulation type is none of the following: OPEN-3, OPEN-8, OPEN-9, OPEN-K, OPEN-E,
OPEN-L, OPEN-M, OPEN-V
•
The volume size is less than 512 MB.
•
Dynamic Link Manager does not exist on the host, and multiple paths are assigned to the volume.
2.
Summary of Changes (see section
). Check and confirm the expansion information.
In HP-UX, there are operations you must perform before and after you expand file systems used as cluster
resources. These operations are described in
.
To start the steps:
1.
In the navigation frame, expand the Hosts tree. A list is displayed of all hosts that are within the access
scope of the user.
2.
Expand the tree of the desired host. The navigation frame displays File Systems and Device Files.
3.
Select MountPoint under File Systems in the navigation frame. The MountPoint subwindow is displayed.
4.
From the MountPoint subwindow, select Expand File System. The Expand File System - Step 1 of 2
dialog box is displayed.
The following sections show the Expand File System dialog boxes and describes the settings to be specified at
each step.
IMPORTANT:
To verify that the correct content was included in each step, you can click the Back button to
return to the previous step. However, if you return to the previous step and then go to the next step, the
selected volume may change, as Provisioning Manager selects the appropriate volume.
7-5-1 Selecting a Volume
In this step, you select a newly allocated volume to be used to expand the file system.
shows the
Expand File System dialog box for selecting the volume (step 1 of 2).
IMPORTANT:
The Expand File System - Step 1 of 2 dialog box is displayed only for volumes for which LUN
security is set for the host. Volumes used by hosts for which security is switched off or storage subsystems
that do not have the security facility are not displayed.
Figure 7-6
Expand File System - Step 1 of 2 (Select Volume)