Teledyne LeCroy Summit T28 PCIe Multi-lane Protocol Analyzer User Manual - Manual (Page 30)

Teledyne LeCroy Using Probes
18 Summit T28 PCI Express Multi‐Lane Protocol Analyzer User Manual
3.7.3 Example: Connecting the Summit T28 Analyzer to the Device Under Test
Using a Gen2 Multi-lead Probe for x8
Components
 2 iPass Straight cables for x8
Figure 3.14: iPass Straight Cables
 2 Multi‐lead Probe pods for x8
(See
“1 Multi‐lead Probe Pod for x1 and x4” on page 16 ).
 Up to 16 MidBus Probe SSMP Cables, and up to 8 Flexible Leads, per pod.
(See
Figure 3.12 on page 16 ).
 1 Clock Cable ( see Figure 3.9 on page 14 ).
Connections Overview for Gen2 Multi-lead Probe
Use a 1‐pod setup.
For x8, use the straight iPass cable to connect the probe data connectors on the Analyzer
to the pod(s).
On the other side of the pod, connect the flexible lead tips.
Connection Procedure
To connect Summit T28 to the system under test (host platform/root complex):
1. Connect the pods to the Analyzer using the straight iPass cables.
2. Connect the flexible lead tips to the pods using the SSMP cables.
3. Connect the lead tips to the system under test by soldering to the trace.