Teledyne LeCroy Summit T28 PCIe Multi-lane Protocol Analyzer User Manual - Manual (Page 23)

Summit T28 PCI Express Multi‐Lane Protocol Analyzer User Manual 11
Interposers and Probes Teledyne LeCroy
3.5 Interposers and Probes
The Summit T28 works with Interposers and Probes. Some of them are listed below.
 Gen2 MidBus Probe: The Gen2 MidBus Probe is designed for use with the
Summit T28 Analyzer and supports lane widths from x1 to x8 at data rates of
2.5 GT/s (Gen1) or 5.0 GT/s (Gen2).
 Gen2 Multi‐lead Probe: The Gen2 Multi‐lead Probe is designed for use with the
Summit T28 Protocol Analyzer. The probe consists of 1 to 2 probe pods, which
are connected to the analyzer using either iPass Y‐Cables (for x1 and x4) or
straight x4‐to‐x8 iPass cables (for x8). Each probe pod supports up to 8 Flex Tips,
with each Flex Tip connected via two coax cables.
 Gen2 Active Slot Interposer: The Gen2 Active Slot Interposer is designed for use
with the Summit T28 Analyzer and supports lane widths from x1 to x8 at data
rates of 2.5 GT/s (Gen1) or 5.0 GT/s (Gen2). For lane widths up to x8, one iPass Y‐
cable is required.
Please refer to the Interposers and Probes for Teledyne LeCroy PCI Express Systems
datasheet at www.Teledynelecroy.com for a comprehensive list.
The following sections describe how to set up probe systems.