Teledyne LeCroy Summit T28 PCIe Multi-lane Protocol Analyzer User Manual - Manual (Page 28)

Teledyne LeCroy Using Probes
16 Summit T28 PCI Express Multi‐Lane Protocol Analyzer User Manual
3.7.2 Example: Connecting the Summit T28 Analyzer to the Device Under Test
Using a Gen2 Multi-lead Probe for x1 and x4
Components
 1 iPass Y‐cable for x1 and x4 (see “iPass Y‐cable” on page 14 ).
 1 Multi‐lead Probe Pod for x1 and x4
Figure 3.12: Multi-Lead Probe Pod
 Up to 16 MidBus Probe SSMP Cables, and up to 8 Flexible Leads, per pod
Figure 3.13: Midbus Probe SSMP Cables
 1 Clock Cable (see Figure 3.10 on page 15 ).
Connections for Gen2 Multi-lead Probe
Overview
Use a 1‐pod setup.
For x1 or x4, use the iPass Y‐cable to connect the probe data connectors on the Analyzer
to the pod(s).
On the other side of the pod, connect the flexible lead tips.