Teledyne LeCroy Summit T28 PCIe Multi-lane Protocol Analyzer User Manual - Manual (Page 110)

Teledyne LeCroy Probe Settings
98 Summit T28 PCI Express Multi‐Lane Protocol Analyzer User Manual
Figure 5.51: Probe Settings Tab
You can auto configure the probe settings by clicking on the Auto Configure button. In
order to calibrate the device the link should be trained to the widest width and the
highest speed. Specify the link width, speed and lane polarity click Start Calibration (see
Figure 5.52 on page 99 ). By default, the polarity settings are carried over from the
recording options menu.