LevelOne FGL-2870 - Manual (Page 94)

Configuring the Switch
3-40
3
• Severity – Sets the syslog severity threshold level (see table on page 3-36) used
to trigger alert messages. All events at this level or higher will be sent to the
configured email recipients. For example, using Level 7 will report all events from
level 7 to level 0. (Default: Level 7)
• SMTP Server List – Specifies a list of up to three recipient SMTP servers. The
switch attempts to connect to the other listed servers if the first fails. Use the New
SMTP Server text field and the Add/Remove buttons to configure the list.
• SMTP Server – Specifies a new SMTP server address to add to the SMTP Server
List.
• Email Destination Address List – Specifies the email recipients of alert
messages. You can specify up to five recipients. Use the New Email Destination
Address text field and the Add/Remove buttons to configure the list.
• Email Destination Address – This command specifies SMTP servers that may
receive alert messages.
Web – Click System, Log, SMTP. Enable SMTP, specify a source email address,
and select the minimum severity level. To add an IP address to the SMTP Server
List, type the new IP address in the SMTP Server field and click Add. To delete an IP
address, click the entry in the Server IP List and click Remove. Specify up to five
email addresses to receive the alert messages, and click Apply.
Figure 3-22 Enabling and Configuring SMTP