LevelOne FGL-2870 - Manual (Page 534)

Command Line Interface
4-168
4
Note: Any configuration changes for dynamic QoS are not saved to the switch
configuration file.
Example
The following example enables the dynamic QoS feature on port 1.
network-access link-detection
Use this command to enable link detection for the selected port. Use the no form of
this command to restore the default.
Syntax
[no] network-access link-detection
Default Setting
Disabled
Command Mode
Interface Configuration
Example
network-access link-detection link-down
Use this command to detect link-down events. When detected, the switch can shut
down the port, send an SNMP trap, or both. Use the no form of this command to
disable this feature.
Syntax
network-access link-detection link-down
action [shutdown | trap | trap-and-shutdown]
no network-access link-detection
Default Setting
Disabled
Command Mode
Interface Configuration
Console(config)#interface ethernet 1/1
Console(config-if)#network-access dynamic-qos
Console(config-if)#
Console(config)#interface ethernet 1/1
Console(config-if)#network-access link-detection
Console(config-if)#