LevelOne FGL-2870 - Manual (Page 404)

Command Line Interface
4-38
4
• The maximum number of user-defined configuration files depends on
available memory.
• You can use “Factory_Default_Config.cfg” as the source to copy from the
factory default configuration file, but you cannot use it as the destination.
• To replace the startup configuration, you must use startup-config as the
destination.
• The Boot ROM and Loader can be downloaded from an FTP/TFTP server, but
cannot be uploaded from the switch to a file server.
• For information on specifying an https-certificate, see "Replacing the Default
Secure-site Certificate" on page 3-89. For information on configuring the
switch to use HTTPS for a secure connection, see "ip http secure-server" on
page 4-133.
• When logging into an FTP server, the interface prompts for a user name and
password configured on the remote server. Note that “anonymous” is set as
the default user name.
Example
The following example shows how to download new firmware from a TFTP server:
The following example shows how to upload the configuration settings to a file on
the TFTP server:
The following example shows how to copy the running configuration to a startup file.
Console#copy tftp file
TFTP server ip address: 10.1.0.19
Choose file type:
1. config: 2. opcode: <1-2>: 2
Source file name: V3.1.16.20.BIX
Destination file name: V311620
\Write to FLASH Programming.
-Write to FLASH finish.
Success.
Console#
Console#copy file tftp
Choose file type:
1. config: 2. opcode: <1-2>: 1
Source file name: startup
TFTP server ip address: 10.1.0.99
Destination file name: startup.01
TFTP completed.
Success.
Console#
Console#copy running-config file
destination file name: startup
Write to FLASH Programming.
\Write to FLASH finish.
Success.
Console#