LevelOne FGL-2870 - Manual (Page 749)

Multicast Filtering Commands
4-383
4
Static Multicast Routing Commands
This section describes commands used to configure static multicast routing on the
switch.
ip igmp snooping vlan mrouter
This command statically configures a multicast router port. Use the no form to
remove the configuration.
Syntax
[no] ip igmp snooping vlan vlan-id mrouter interface
• vlan-id - VLAN ID (Range: 1-4094)
• interface
• ethernet unit/port
- unit - Stack unit. (Range: 1)
- port - Port number. (Range: 1-28/52)
• port-channel channel-id (Range: 1-8)
Default Setting
No static multicast router ports are configured.
Command Mode
Global Configuration
Command Usage
Depending on your network connections, IGMP snooping may not always be
able to locate the IGMP querier. Therefore, if the IGMP querier is a known
multicast router/switch connected over the network to an interface (port or
trunk) on your router, you can manually configure that interface to join all the
current multicast groups.
Example
The following shows how to configure port 11 as a multicast router port within VLAN 1:
Table 4-93 Static Multicast Routing Commands
Command Function Mode Page
ip igmp snooping vlan mrouter Adds a multicast router port GC 4-383
show ip igmp snooping mrouter Shows multicast router ports PE 4-384
Console(config)#ip igmp snooping vlan 1 mrouter ethernet 1/11
Console(config)#