Clock summer-time (recurring) – LevelOne FGL-2870 User Manual

Page 444

Command Line Interface

4-78

Example

Related Commands

clock summer-time (recurring)

This command allows the user to manually configure the start, end, and offset times
of summer time (daylight savings time) for the switch on a recurring basis. Use the
no form to disable summer-time.

Syntax

clock summer-time name recurring b-week b-day b-month b-hour b-minute

e-week e-day e-month e-hour e-minute offset

no clock summer-time

• name - Name of the timezone while summer time is in effect, usually an

acronym. (Range: 1-30 characters)

• b-week - The week of the month when summer time will begin. (Range: 1-5)
• b-day - The day of the week when summer time will begin. (Options:

• b-month - The month when summer time will begin. (Options: january |

• b-hour - The hour when summer time will begin. (Range: 0-23 hours)
• b-minute - The minute when summer time will begin. (Range: 0-59 minutes)
• e-week - The week of the month when summer time will end. (Range: 1-5)
• e-day - The day of the week summer time will end. (Options: sunday |

• e-month - The month when summer time will end. (Options: january |

• e-hour - The hour when summer time will end. (Range: 0-23 hours)
• e-minute - The minute when summer time will end. (Range: 0-59 minutes)
• offset - Summer-time offset from the regular time zone, in minutes.

(Range: 0-99 minutes)

Default Setting

Disabled

New Zealand 00:00:00, Sunday, Week 1 of October 23:59:59, Sunday, Week 3 of March

60 min

USA

02:00:00, Sunday, Week 2 of March

02:00:00, Sunday, Week 1 of November

60 min

Console(config)#clock summer-time MESZ predefined europe
Console(config)#

Table 4-19 Predefined Summer-Time Parameters

Region

Start Time, Day, Week, & Month

End Time, Day, Week, & Month

Rel. Offset