LevelOne FGL-2870 - Manual (Page 572)

Command Line Interface
4-206
4
access-list ipv6
This command adds an IP access list and enters configuration mode for standard or
extended IPv6 ACLs. Use the no form to remove the specified ACL.
Syntax
[no] access-list ipv6 {standard | extended} acl-name
• standard – Specifies an ACL that filters packets based on the source IP
address.
• extended – Specifies an ACL that filters packets based on the destination
IP address, and other more specific criteria.
• acl-name – Name of the ACL. (Maximum length: 16 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
• When you create a new ACL or enter configuration mode for an existing ACL,
use the permit or deny command to add new rules to the bottom of the list.
To create an ACL, you must add at least one rule to the list.
• To remove a rule, use the no permit or no deny command followed by the
exact text of a previously configured rule.
• An ACL can contain up to 64 rules.
Example
Related Commands
permit, deny (4-207)
ipv6 access-group (4-209)
show ipv6 access-list (4-209)
Console(config)#access-list ipv6 standard david
Console(config-std-ipv6-acl)#