LevelOne FGL-2870 - Manual (Page 585)

Interface Commands
4-219
4
Interface Commands
These commands are used to display or set communication parameters for an
Ethernet port, aggregated link, or VLAN.
Table 4-55 Interface Commands
Command Function Mode Page
interface Configures an interface type and enters interface configuration
mode
GC 4-220
description Adds a description to an interface configuration IC 4-220
speed-duplex Configures the speed and duplex operation of a given interface
when autonegotiation is disabled
IC 4-221
negotiation Enables autonegotiation of a given interface IC 4-222
capabilities Advertises the capabilities of a given interface for use in
autonegotiation
IC 4-223
flowcontrol Enables flow control on a given interface IC 4-224
media-type Forces port type selected for combination ports IC 4-225
giga-phy-mode Forces two connected ports in to a master/slave configuration to
enable 1000BASE-T full duplex
IC 4-225
shutdown Disables an interface IC 4-226
switchport packet-rate *
* Enabling hardware-level storm control with this command on a port will disable software-level automatic storm
control on the same port if configured by the auto-traffic-control command (page 4-238).
Configures storm control thresholds IC 4-227
clear counters Clears statistics on an interface PE 4-228
show interfaces brief Displays a summary of key information, including operational
status, native VLAN ID, default priority, speed/duplex mode, and
port type
PE 4-228
show interfaces status Displays status for the specified interface NE, PE 4-229
show interfaces
counters
Displays statistics for the specified interfaces NE, PE 4-230
show interfaces
switchport
Displays the administrative and operational status of an
interface
NE, PE 4-231