LevelOne FGL-2870 - Manual (Page 580)

Command Line Interface
4-214
4
MAC ACLs
The commands in this section configure ACLs based on hardware addresses,
packet format, and Ethernet type. To configure MAC ACLs, first create an access list
containing the required permit or deny rules, and then bind the access list to one or
more ports.
access-list mac
This command adds a MAC access list and enters MAC ACL configuration mode.
Use the no form to remove the specified ACL.
Syntax
[no] access-list mac acl-name
acl-name – Name of the ACL. (Maximum length: 16 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
• When you create a new ACL or enter configuration mode for an existing ACL,
use the permit or deny command to add new rules to the bottom of the list.
To create an ACL, you must add at least one rule to the list.
• To remove a rule, use the no permit or no deny command followed by the
exact text of a previously configured rule.
• An ACL can contain up to 64 rules.
Example
Related Commands
permit, deny (4-215)
mac access-group (4-217)
show mac access-list (4-216)
Table 4-53 MAC ACL Commands
Command Function Mode Page
access-list mac Creates a MAC ACL and enters configuration mode GC 4-214
permit, deny Filters packets matching a specified source and
destination address, packet format, and Ethernet type
MAC-ACL 4-215
show mac access-list Displays the rules for configured MAC ACLs PE 4-216
mac access-group Adds a port to a MAC ACL IC 4-217
show mac access-group Shows port assignments for MAC ACLs PE 4-217
Console(config)#access-list mac jerry
Console(config-mac-acl)#