LevelOne FGL-2870 - Manual (Page 471)

Flow Sampling Commands
4-105
4
sflow owner
This command configures the name of the receiver (i.e., sFlow Collector). Use the
no form to remove this name.
Syntax
sflow owner name
no sflow owner
name - The name of the receiver. (Range: 1-256 characters)
Default Setting
None
Command Mode
Interface Configuration (Ethernet)
Example
This example set the owner’s name to Lamar.
sflow timeout
This command configures the length of time samples are sent to the Collector
before resetting all sFlow port parameters. Use the no form to restore the default
time out.
Syntax
sflow timeout seconds
no sflow timeout
seconds - The length of time the sFlow process continuously sends
samples to the Collector before resetting all sFlow port parameters.
(Range: 0-10000000 seconds, where 0 indicates no time out)
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
Command Usage
The sFlow parameters affected by this command include the sampling interval,
the receiver’s name, address and UDP port, the time out, maximum header
size, and maximum datagram size.
Console(config)#interface ethernet 1/9
Console(config-if)#sflow owner Lamer
Console(config-if)#