LevelOne FGL-2870 - Manual (Page 659)

VLAN Commands
4-293
4
show spanning-tree mst configuration
This command shows the configuration of the multiple spanning tree.
Command Mode
Privileged Exec
Example
VLAN Commands
A VLAN is a group of ports that can be located anywhere in the network, but
communicate as though they belong to the same physical segment. This section
describes commands used to create VLAN groups, add port members, specify how
VLAN tagging is used, and enable automatic VLAN registration for the selected
interface.
Console#show spanning-tree mst configuration
Mstp Configuration Information
--------------------------------------------------------------
Configuration name: R&D
Revision level:0
Instance Vlans
--------------------------------------------------------------
0 1,3-4094
1 2
Console#
Table 4-70 VLAN Command Groups
Command Groups Function Page
GVRP and Bridge Extension Configures GVRP settings that permit automatic VLAN learning;
shows the configuration for bridge extension MIB
4-294
Editing VLAN Groups Sets up VLAN groups, including name, VID and state 4-298
Configuring VLAN
Interfaces
Configures VLAN interface parameters, including ingress and egress
tagging mode, ingress filtering, PVID, and GVRP
4-300
Displaying VLAN
Information
Displays VLAN groups, status, port members, and MAC addresses 4-307
Configuring 802.1Q
Tunneling
Configures 802.1Q Tunneling (QinQ Tunneling) 4-308
Configuring Port-based
Traffic Segmentation
Configures traffic segmentation for different client sessions based on
specified downlink and uplink ports
4-312
Configuring Private VLANs Configures private VLANs, including uplink and downlink ports 4-316
Configuring Protocol VLANs Configures protocol-based VLANs based on frame type and protocol 4-321
Configuring IP Subnet
VLANs
Configures IP Subnet-based VLANs 4-324
Configuring MAC Based
VLANs
Configures MAC-based VLANs 4-326
Configuring Voice VLANs Configures VoIP traffic detection and enables a Voice VLAN 4-328