LevelOne FGL-2870 - Manual (Page 188)

Configuring the Switch
3-134
3
Web – Specify the action (i.e., Permit or Deny). Specify the packet type, the address
type (Any, Host, or MAC), the source and/or destination addresses. If you select
“Host,” enter a specific address. If you select “IP” or “MAC,” enter a base address
and a hexadecimal bitmask for an address range. Enable logging if required. Then
click Add.
Figure 3-80 ACL Configuration - ARP
CLI – This rule permits packets from any source IP and MAC address to the
destination subnet address 192.168.0.0.
Console(config-arp-acl)#permit response ip any 192.168.0.0 255.255.0.0 mac
any any 4-212
Console(config-arp-acl)#