LevelOne FGL-2870 - Manual (Page 603)

Automatic Traffic Control Commands
4-237
4
Command Usage
After the apply timer expires, a control action may be triggered as specified by
the auto-traffic-control action command (page 4-240) and a trap message
sent as specified by the snmp-server enable port-traps atc
broadcast-control-apply command (page 4-244) or snmp-server enable
port-traps atc multicast-control-apply command (page 4-245).
Example
This example sets the apply timer to 200 seconds for all ports.
auto-traffic-control release-timer
This command sets the time at which to release the control response after ingress
traffic has fallen beneath the lower threshold. Use the no form to restore the default
setting.
Syntax
auto-traffic-control {broadcast | multicast} release-timer seconds
no auto-traffic-control {broadcast | multicast} release-timer
• broadcast - Specifies automatic storm control for broadcast traffic.
• multicast - Specifies automatic storm control for multicast traffic.
• seconds - The time at which to release the control response after ingress
traffic has fallen beneath the lower threshold. (Range: 1-900 seconds)
Default Setting
900 seconds
Command Mode
Global Configuration
Command Usage
This command sets the delay after which the control response can be
terminated. The auto-traffic-control auto-control-release command
(page 4-242) must be used to enable or disable the automatic release.
Example
This example sets the release timer to 800 seconds for all ports.
Console(config)#auto-traffic-control broadcast apply-timer 200
Console(config)#
Console(config)#auto-traffic-control broadcast release-timer 800
Console(config)#