LevelOne FGL-2870 - Manual (Page 167)

General Security Measures
3-113
3
Configuring Web Authentication for Ports
Web authentication is configured on a per-port basis. The following parameters are
associated with each port.
Command Attributes
• Port – Indicates the port being configured
• Status – Configures the web authentication status for the port.
• Authenticated Host Counts – Indicates how many authenticated hosts are
connected to the port.
Web – Click Security, Web Authentication, Port Configuration. Set the status box to
enabled for any port that requires web authentication, and click Apply.
Figure 3-66 Web Authentication Port Configuration
CLI – This example enables web authentication for ethernet port 1/5 and displays a
summary of web authentication parameters.
Console(config)#interface ethernet 1/5 4-220
Console(config-if)#web-auth 4-175
Console(config-if)#end
Console#show web-auth summary
4-178
Global Web-Auth Parameters
System Auth Control : Enabled
Port Status Authenticated Host Count
---- ------ ------------------------
1/ 1 Disabled 0
1/ 2 Enabled 0
1/ 3 Disabled 0
1/ 4 Disabled 0
1/ 5 Enabled 0
1/ 6 Disabled 0
1/ 7 Disabled 0
1/ 8 Disabled 0
1/ 9 Disabled 0
.
.
.