LevelOne FGL-2870 - Manual (Page 641)

Spanning Tree Commands
4-275
4
Command Mode
Global Configuration
Command Usage
This command limits the maximum transmission rate for BPDUs.
Example
spanning-tree mst-configuration
This command changes to Multiple Spanning Tree (MST) configuration mode.
Default Setting
• No VLANs are mapped to any MST instance.
• The region name is set the switch’s MAC address.
Command Mode
Global Configuration
Example
Related Commands
mst vlan (4-275)
mst priority (4-276)
name (4-277)
revision (4-277)
max-hops (4-278)
mst vlan
This command adds VLANs to a spanning tree instance. Use the no form to remove
the specified VLANs. Using the no form without any VLAN parameters to remove all
VLANs.
Syntax
[no] mst instance-id vlan vlan-range
• instance-id - Instance identifier of the spanning tree. (Range: 0-4094)
• vlan-range - Range of VLANs. (Range: 1-4094)
Default Setting
none
Command Mode
MST Configuration
Console(config)#spanning-tree transmission-limit 4
Console(config)#
Console(config)#spanning-tree mst configuration
Console(config-mstp)#