Configuring parameters for lacp groups – LevelOne FGL-2870 User Manual
Page 220

Configuring the Switch
3-166
3
Configuring Parameters for LACP Groups
Use the Aggregator page to configure system parameters which apply to specific
LACP groups.
Command Attributes
• Admin Key – LACP administration key is used to identify a specific link
aggregation group (LAG) during local LACP setup on the switch. (Range: 0-65535)
Ports are only allowed to join the same LAG if (1) the LACP port system priority
matches, (2) the LACP port admin key matches, and (3) the LACP port channel
admin key matches (if configured).
If the port channel admin key is not set when a channel group is formed (that is, it
has the null value of 0), this key is set to the same value as the port admin key used
by the interfaces that joined the group. Note that when the LAG is no longer used,
the port channel admin key is reset to 0.
Console#show lacp sysid
Port Channel System Priority System MAC Address
-------------------------------------------------------------------------
1 32768 00-12-CF-BE-21-DE
2 32768 00-12-CF-BE-21-DE
3 32768 00-12-CF-BE-21-DE
4 32768 00-12-CF-BE-21-DE
Console#show lacp 1 internal
Port Channel: 1
-------------------------------------------------------------------------
Oper Key: 120
Admin Key: 0
Eth 1/1
-------------------------------------------------------------------------
LACPDUs Internal: 30 sec
LACP System Priority: 3
LACP Port Priority: 128
Admin Key: 120
Oper Key: 120
Admin State : defaulted, aggregation, long timeout, LACP-activity
Oper State: distributing, collecting, synchronization,
aggregation, long timeout, LACP-activity
.
.
.