LevelOne FGL-2870 - Manual (Page 431)

System Management Commands
4-65
4
logging sendmail destination-email
This command specifies the email recipients of alert messages. Use the no form to
remove a recipient.
Syntax
[no] logging sendmail destination-email email-address
email-address - The source email address used in alert messages.
(Range: 1-41 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
You can specify up to five recipients for alert messages. However, you must
enter a separate command to specify each recipient.
Example
logging sendmail
This command enables SMTP event handling. Use the no form to disable this
function.
Syntax
[no] logging sendmail
Default Setting
Enabled
Command Mode
Global Configuration
Example
show logging sendmail
This command displays the settings for the SMTP event handler.
Command Mode
Normal Exec, Privileged Exec
Console(config)#logging sendmail destination-email [email protected]
Console(config)#
Console(config)#logging sendmail
Console(config)#