LevelOne FGL-2870 - Manual (Page 295)

Link Layer Discovery Protocol
3-241
3
The MED Fast Start Count parameter is part of the timer which ensures that the
LLDP-MED Fast Start mechanism is active for the port. LLDP-MED Fast Start is
critical to the timely startup of LLDP, and therefore integral to the rapid availability
of Emergency Call Service.
Web – Click LLDP, Configuration. Enable LLDP, modify any of the timing parameters
as required, and click Apply.
Figure 3-138 LLDP Configuration
CLI – This example sets several attributes which control basic LLDP message timing.
Configuring LLDP Interface Attributes
Use the LLDP Port/Trunk Configuration to specify the message attributes for
individual interfaces, including whether messages are transmitted, received, or both
transmitted and received, whether SNMP notifications are sent, and the type of
information advertised.
Console(config)#lldp 4-337
Console(config)#lldp refresh-interval 60 4-339
Console(config)#lldp holdtime-multiplier 10 4-337
Console(config)#lldp tx-delay 10 4-340
Console(config)#lldp reinit-delay 10 4-339
Console(config)#lldp notification-interval 30 4-338
Console(config)#lldp medFastStartCount 6
4-338
Console(config)#exit
Console#show lldp config
LLDP Global Configuation
LLDP Enable : Yes
LLDP Transmit interval : 60
LLDP Hold Time Multiplier : 10
LLDP Delay Interval : 10
LLDP Reinit Delay : 10
LLDP Notification Interval : 30
.
.
.