LevelOne FGL-2870 - Manual (Page 600)

Command Line Interface
4-234
4
SNMP Trap Commands
snmp-server
enable port-traps atc
broadcast-alarm-fire
Sends a trap when broadcast traffic exceeds the upper
threshold for automatic storm control
IC (Port) 4-242
snmp-server
enable port-traps atc
multicast-alarm-fire
Sends a trap when multicast traffic exceeds the upper
threshold for automatic storm control
IC (Port) 4-243
snmp-server
enable port-traps atc
broadcast-alarm-clear
Sends a trap when broadcast traffic falls beneath the
lower threshold after a storm control response has been
triggered
IC (Port) 4-243
snmp-server
enable port-traps atc
multicast-alarm-clear
Sends a trap when multicast traffic falls beneath the lower
threshold after a storm control response has been
triggered
IC (Port) 4-244
snmp-server
enable port-traps atc
broadcast-control-apply
Sends a trap when broadcast traffic exceeds the upper
threshold for automatic storm control and the apply timer
expires
IC (Port) 4-244
snmp-server
enable port-traps atc
multicast-control-apply
Sends a trap when multicast traffic exceeds the upper
threshold for automatic storm control and the apply timer
expires
IC (Port) 4-245
snmp-server
enable port-traps atc
broadcast-control-release
Sends a trap when broadcast traffic falls beneath the
lower threshold after a storm control response has been
triggered and the release timer expires
IC (Port) 4-245
snmp-server
enable port-traps atc
multicast-control-release
Sends a trap when multicast traffic falls beneath the lower
threshold after a storm control response has been
triggered and the release timer expires
IC (Port) 4-246
ATC Display Commands
show auto-traffic-control
Shows global configuration settings for automatic storm
control
PE 4-246
show auto-traffic-control
interface
Shows interface configuration settings and storm control
status for the specified port
PE 4-247
* Enabling automatic storm control on a port will disable hardware-level storm control on the same port if configured
by the switchport packet-rate command (page 4-227).
Table 4-57 ATC Commands (Continued)
Command Function Mode Page