LevelOne FGL-2870 - Manual (Page 591)

Interface Commands
4-225
4
media-type
This command forces the port type selected for combination ports 25-28 (FGL-2870)
. Use the no form to restore the default mode.
Syntax
media-type mode
no media-type
mode
• copper-forced - Always uses the built-in RJ-45 port.
• sfp-forced - Always uses the SFP port (even if module not installed).
• sfp-preferred-auto - Uses SFP port if both combination types are
functioning and the SFP port has a valid link.
Default Setting
sfp-preferred-auto
Command Mode
Interface Configuration (Ethernet - Ports 25-28/49-52)
Example
This forces the switch to use the built-in RJ-45 port for the combination port 25.
giga-phy-mode
This command forces two connected ports in to a master/slave configuration to
enable 1000BASE-T full duplex for Gigabit ports 25-28 (FGL-2870). Use the no form
to restore the default mode.
Syntax
giga-phy-mode mode
no giga-phy-mode
mode
• master - Sets the selected port as master.
• slave - Sets the selected port as slave.
• auto-prefer-master - Uses master mode as the initial configuration
setting regardless of the mode configured at the other end of the link.
• auto-prefer-slave - Uses slave mode as the initial configuration
regardless of the mode configured at the other end of the link.
Default Setting
master
Command Mode
Interface Configuration (Ethernet - Ports 25-28/49-52)
Console(config)#interface ethernet 1/25
Console(config-if)#media-type copper-forced
Console(config-if)#