LevelOne FGL-2870 - Manual (Page 576)

Command Line Interface
4-210
4
Example
Related Commands
show ipv6 access-list (4-209)
show ipv6 access-group
This command shows the ports assigned to IPv6 ACLs.
Command Mode
Privileged Exec
Example
Related Commands
ipv6 access-group (4-209)
ARP ACLs
The commands in this section configure ACLs based on the IP or MAC address
contained in ARP request and reply messages. To configure ARP ACLs, first create
an access list containing the required permit or deny rules, and then bind the access
list to one or more VLANs using the ip arp inspection vlan command (page 4-191).
Console(config)#int eth 1/2
Console(config-if)#ipv6 access-group standard david in
Console(config-if)#
Console#show ip access-group
Interface ethernet 1/2
IPv6 standard access-list david in
Console#
Table 4-52 ARP ACL Commands
Command Function Mode Page
access-list arp Creates a ARP ACL and enters configuration mode GC 4-211
permit, deny Filters packets matching a specified source or destination
address in ARP messages
ARP-ACL 4-212
show arp access-list Displays the rules for configured ARP ACLs PE 4-213