LevelOne FGL-2870 - Manual (Page 562)

Command Line Interface
4-196
4
Example
show ip arp inspection configuration
This command displays the global configuration settings for ARP Inspection.
Command Mode
Privileged Exec
Example
show ip arp inspection interface
This command shows the trust status and ARP Inspection rate limit for ports.
Syntax
ip arp inspection interface [interface]
interface
ethernet unit/port
• unit - Stack unit. (Range: 1)
• port - Port number. (Range: 1-28/52)
Command Mode
Privileged Exec
Example
Console(config)#interface ethernet 1/1
Console(config-if)#ip arp inspection limit 150
Console(config-if)#
Console#show ip arp inspection configuration
ARP inspection global information:
Global IP ARP Inspection status : disabled
Log Message Interval : 10 s
Log Message Number : 1
Need Additional Validation(s) : Yes
Additional Validation Type : Destination MAC address
Console#
Console#show ip arp inspection interface ethernet 1/1
Port Number Trust Status Limit Rate (pps)
------------- -------------------- ------------------------------
Eth 1/1 trusted 150
Console#