LevelOne FGL-2870 - Manual (Page 518)

Command Line Interface
4-152
4
For guest VLAN assignment to be successful, the VLAN must be configured
and set as active ("vlan database" on page 4-298) and assigned as the guest
VLAN for the port ("network-access guest-vlan" on page 4-166).
Example
show dot1x
This command shows general port authentication related settings on the switch or a
specific interface.
Syntax
show dot1x [statistics] [interface interface]
• statistics - Displays dot1x status for each port.
• interface
• ethernet unit/port
- unit - Stack unit. (Range: 1)
- port - Port number. (Range: 1-28/52)
Command Mode
Privileged Exec
Command Usage
This command displays the following information:
• Global 802.1X Parameters – Shows whether or not 802.1X port
authentication is globally enabled on the switch.
• 802.1X Port Summary – Displays the port access control parameters for
each interface, including the following items:
- Status
– Administrative state for port access control.
- Operation Mode – Dot1x port control operation mode (page 4-147).
- Mode – Dot1x port control mode (page 4-146).
- Authorized – Authorization status (yes or n/a - not authorized).
• 802.1X Port Details – Displays the port access control parameters for each
interface, including the following items:
- reauth-enabled
– Periodic re-authentication (page 4-149).
- reauth-period – Time after which a connected client must be
re-authenticated (page 4-150).
- quiet-period – Time a port waits after Max Request Count is
exceeded before attempting to acquire a new
client (page 4-149).
- tx-period – Time a port waits during authentication session
before re-transmitting EAP packet (page 4-150).
- supplicant-timeout – Supplicant timeout.
Console(config)#interface eth 1/2
Console(config-if)#dot1x intrusion-action guest-vlan
Console(config-if)#