LevelOne FGL-2870 - Manual (Page 452)

Command Line Interface
4-86
4
discarded. (Range:1-255)
Default Setting
4
Command Mode
Global Configuration
Command Usage
UPnP devices and control points must be within the local network, that is
within the TTL value for multicast messages.
Example
In the following example, the TTL is set to 6.
upnp device advertise duration
This command sets the duration for which a device will advertise its presence on the
local network.
Syntax
upnp device advertise duration value
value - A time out value expressed in seconds. (Range: 6-86400 seconds)
Default Setting
100 seconds
Command Mode
Global Configuration
Example
In the following example, the device advertise duration is set to 200 seconds.
Related Commands
upnp device ttl (4-85)
show upnp
This command displays the UPnP management status and time out settings.
Command Mode
Privileged Exec
Console(config)#upnp device ttl 6
Console(config)#
Console(config)#upnp device advertise duration 200
Console(config)#