LevelOne FGL-2870 - Manual (Page 706)

Command Line Interface
4-340
4
Command Mode
Global Configuration
Command Usage
When LLDP is re-initialized on a port, all information in the remote systems
LLDP MIB associated with this port is deleted.
Example
lldp tx-delay
This command configures a delay between the successive transmission of
advertisements initiated by a change in local LLDP MIB variables. Use the no form
to restore the default setting.
Syntax
lldp tx -delay seconds
no lldp tx -delay
seconds - Specifies the transmit delay. (Range: 1 - 8192 seconds)
Default Setting
2 seconds
Command Mode
Global Configuration
Command Usage
• The transmit delay is used to prevent a series of successive LLDP
transmissions during a short period of rapid changes in local LLDP MIB
objects, and to increase the probability that multiple, rather than single
changes, are reported in each transmission.
• This attribute must comply with the following rule:
(4 * tx-delay) ≤ refresh-interval
Example
Console(config)#lldp reinit-delay 10
Console(config)#
Console(config)#lldp tx-delay 10
Console(config)#