FEC FUSIONE-HS-2 - Manual (Page 75)

FEC FUSION Operations Manual Chapter 4: System Setup and Wiring (Rev. 2.1)
Page 4-37
4.14.2 Ethernet Module Connection
The Ethernet Module connections are shown below. Note that the power for the module is
supplied from the Fusion controller TB1 terminal. Optional Work Select terminations only
need to be made if the desired Ethernet protocol requires selection of work selects by Ether-
net.
Fig. 4.14.2 Ethernet Module Connection
Connection to an Ethernet network is done by using the RJ-45 Ethernet port on the Ethernet
module. (Set-up of the TCP/IP configuration must be completed in the module set-up before
communication can take place) After Connection to an Ethernet network, the Ethernet status
is displayed on the Ethernet Status display LED’s located just above the RJ-45 Ethernet con-
nection port (shown to the left of the Ethernet port on the drawing above)
Ethernet Status LED
Link
Active
Link: LED is “ON” (solid) when link is established
Active: LED flashes during data transmission