FEC FUSIONE-HS-2 - Manual (Page 48)

Chapter 4: System Setup and Wiring
4.6 Power Requirements and Connections
4.6.1 Controller Unit
The Controller uses a standard “computer” power cord which connects to the AC power co
nector located at the back of the unit and to a standard wall outlet.
gle phase power (100-240VAC 50/60Hz). Power consumption is 80watts
1200watts @ max. Torque. Inrush current
WARNING: Do not disconnect power cable while system is in cycle.
PIN NUMBER DESCRIPTION
1 FRAME GROUND
2 100 – 240 VAC 50/60Hz
3 100 – 240 VAC 50/60Hz
Fig. 4
NOTE:
After a Controller unit is powered down, the power must not be applied again for at
least five (5) seconds. Repeated power up and power down may temporarily disable a
Controller unit as a self protection feature
turn the power off for five (5) minutes before making another attempt to power up.
Page 4-10
Power Requirements and Connections
The Controller uses a standard “computer” power cord which connects to the AC power co
nector located at the back of the unit and to a standard wall outlet. The unit operates on si
240VAC 50/60Hz). Power consumption is 80watts while idle &
. Inrush current (at power on) is 11amps.
Do not disconnect power cable while system is in cycle.
DESCRIPTION
FRAME GROUND
240 VAC 50/60Hz
240 VAC 50/60Hz
Fig. 4-6-1 Controller Unit Power Connector
unit is powered down, the power must not be applied again for at
least five (5) seconds. Repeated power up and power down may temporarily disable a
as a self protection feature. If a Controller unit does become disabled,
ff for five (5) minutes before making another attempt to power up.
The Controller uses a standard “computer” power cord which connects to the AC power con-
The unit operates on sin-
idle &
unit is powered down, the power must not be applied again for at
least five (5) seconds. Repeated power up and power down may temporarily disable a
unit does become disabled,
ff for five (5) minutes before making another attempt to power up.