FEC FUSIONE-HS-2 User Manual
Page 57
FEC FUSION Operations Manual
4.8.2 Rear Panel DB9
Connector: DB-9P (Male)
Mating Connector: DB
PIN
1
2
3
4
5
6
7
8
9
Note:
The CTS signal needs to be activated in order for the fastening data to be output. If it
the data will be overwritten in a First In, First Out (FIFO) process. The CTS signal may be
connected to the RTS signal if data is to be “dumped” at every fastening.
Connection with hardware handshake (
Connection without handshake
¢¡¤£
£
¥§¦¢¨
©
©
!" ©
#
¤
$&%
©
')(10
2§3)4¢5
6879@A
B)C 6
D"C 6
D&B¤9
E
B19
F"G
6
FEC FUSION Operations Manual
Chapter 4: System Setup and Wiring (Rev. 2.1)
Page 4-19
DB9 RS232 PC Connection (Fastening Data Output)
9P (Male)
Mating Connector: DB-9S (Female)
SIGNAL
DESCRIPTION
NOT USED
RXD
NOT USED
TXD
TRANSMIT DATA
DTR
DATA TERMINAL READY (ALWAYS ON)
GND
SIGNAL GROUND
DSR
NOT USED
RTS
REQUEST TO SEND (ALWAYS ON)
CTS
CLEAR TO SEND
NOT USED
The CTS signal needs to be activated in order for the fastening data to be output. If it
the data will be overwritten in a First In, First Out (FIFO) process. The CTS signal may be
connected to the RTS signal if data is to be “dumped” at every fastening.
Connection with hardware handshake (with DTR signal)
Connection without handshake – data “dumped” (without DTR signal)
¨¢HPIRQS¨)¡¢TVU
PWXTVY
`
Qa£
¡
©Scbad
Qa£
¡
e
e
!" ©
f
g
fih
© !
p
q
$&%
©
5PrtsS4 (Puwv
'PxXuwy
A
s0
(
6"79@A
s0
(
D"C 6
i
68B D
F&G
6
Chapter 4: System Setup and Wiring (Rev. 2.1)
Fastening Data Output)
TERMINAL READY (ALWAYS ON)
The CTS signal needs to be activated in order for the fastening data to be output. If it
the data will be overwritten in a First In, First Out (FIFO) process. The CTS signal may be
connected to the RTS signal if data is to be “dumped” at every fastening.