FEC FUSIONE-HS-2 - Manual (Page 14)

Table of contents
iv
9.4 Tool EEPROM Errors 9-7
9.4.1 Code 3-0 Preamplifier / Tool ID Checksum error 9-7
9.4.2 Code 3-1 Preamplifier / Tool type error 9-7
9.4.3 Code 3-2 Preamplifier / Started without tool connected 9-7
9.4.4 Code 3-3 Preamplifier / Tool is not connected 9-7
9.5 System Memory Errors 9-8
9.5.1 Code 4-0 system memory error / Flash ROM write error 9-8
9.5.2 Code 4-1 system memory error / Flash ROM read error 9-8
9.5.3 Code 4-2 system memory error / Servo Amp Flash ROM error 9-8
9.6 Servo Amplifier Response / Resolver 9-9
9.6.1 Code 5-0 Servo Amplifier reply error / No reply from Resolver 9-9
9.7 Servo Type Error 9-10
9.7.1 Code 6-0 Servo Type error / Servo Type mismatch 9-10
9.9 Servo Amplifier Error 9-11
9.9.1 Code 8-1 Servo Amplifier error / Servo is over heated 9-11
9.9.2 Code 8-4 Servo Amplifier error / Over current 9-11
9.9.3 Code 8-5 Servo Amplifier error /Internal power supply. 9-11
9.9.4 Code 8-6 Servo Amplifier error / Input Voltage abnormal 9-12
9.9.5 Code 8-9 Servo Amplifier error / Over speed. 9-12
9.9.6 Code 8-10 Servo Amplifier error / over load ( I square T) 9-12
9.9.7 Code 8-11 Servo Amplifier error / Resolver Signal Error . 9-12
9.10 Parameter Error 9-13
9.10.1 Code 9-0 Parameter Error / Missing speed preset. 9-13
9.10.2 Code 9-1 Parameter Error/ Missing Speed or Time 9-13
9.10.3 Code 9-2 Parameter Error/ Parameter Select Error 9-13
9.10.4 Code 9-3 Parameter Error/ Missing Reverse Speed 9-13
9.10.5 Code 9-4 Parameter Error/ Torque Speed not set 9-13
9.10.6 Code 9-5 Parameter Error/ Torque Setup Error 9-14
9.10.7 Code 9-6 Parameter Error/ Angle Setup Error 9-14
9.10.8 Code 9-7 Parameter Error/ Reverse Torque over. 9-14
9.11 AFC1500 SAN Unit Fastening Faults and Causes 9-15
9.11.1 Accept Conditions 9-15
9.11.2 Torque Reject Conditions 9-15