FEC FUSIONE-HS-2 - Manual (Page 13)

Table of contents
iii
7.2 Run State Modes. 7-5
7.2.1 Display indication modes. 7-5
7.2.2 Real-time display indication mode. 7-6
7.2.3 Fastening results display mode. 7-7
7.2.4 Parameter display mode 7-8
7.2.5 Parameter Data List & Data Explanation 7-9
7.2.6 Status Display 7-24
7.3 Download / Setup Mode Operation. 7-25
7.3.1 Download Mode selection 7-25
7.3.2 Setup Mode selection 7-26
7.3.3 Parameter Number Selection. 7-27
7.3.4 Data # selection 7-28
7.3.5 Data Edit Mode Operation 7-29
7.3.6 Parameter Copy 7-30
7.4 Calibration adjustment. 7-31
7.5 Optional Real Time Clock Module 7-32
7.6 Tubenut Head Setup 7-33
7.6.1 Recommended Parameter Setup for Tubenut Head 7-34
7.6.2 Tubenut Head Operation 7-35
Chapter 8: Maintenance and Inspection 8-1
8.1 Inspection Items 8-2
8.1.1 Nutrunner (Tool) 8-2
8.1.2 Tool Cable 8-2
8.1.3 Controller Unit 8-3
8.1.4 Auxiliary Tool Heads 8-3
8.2 Basic operational tests 8-4
8.2.1 Torque transducer. 8-4
8.2.2 Resolver. 8-4
8.2.3 Motor. 8-4
8.2.4 Transmission Disassembly and Inspection 8-6
8.3 Replacements 8-7
8.3.1 Controller Unit Replacement 8-7
8.3.2 Replace Nutrunner (tool) 8-8
8.3.3 Replace Homerun cables 8-8
Chapter 9: Troubleshooting 9-1
9.1 Abnormal Conditions. 9-2
9.2 Torque Transducer Abnormals. 9-3
Calibration Error 9-3
9.2.1 Code 1-0 Torque transducer / Zero Voltage error. 9-3
9.2.2 Code 1-1 Torque transducer / Cal Voltage error. 9-3
9.2.3 Code 1-2 Torque transducer / Zero check error. 9-4
9.2.4 Code 1-3 Torque transducer / Cal self-check error. 9-4
9.2.5 Code 1-4 Torque transducer / started on Zero condition error. 9-4
9.2.6 Code 1-5 Torque transducer / started on Cal condition error 9-4
9.2.7 Code 1-6 Torque transducer / Zero Level Self Check Error 9-5
9.3 Torque Over 9-6
9.3.1 Code 2-0 Torque Over Abnormal / Torque Inhibit High Limit 9-6