FEC FUSIONE-HS-2 User Manual

Page 71

FEC FUSION Operations Manual

Chapter 4: System Setup and Wiring (Rev. 2.1)

Page 4-33

4.12 Firmware Flash Connector (CN8)

Upgrades or revisions to Firmware are handled easily with the on board Flash connector lo-

cated behind the access panel on the bottom of each controller Unit. There is no need to re-

move or disassemble the unit. A Flash adapter (CONTROLLER-ROM) containing the new

firmware can be connected to connector CN8 with the power off to the unit. The power is

then cycled on until the ACCEPT LED is blinking indicating the firmware upload is complete.

Turn off power and remove the flash adapter. The firmware update is now complete.

Note: This connector is for FEC use only and it is not recommended for use other than

FEC.

FIG 4-12: CN8 location (CONTROLLER) unit bottom view).