FEC FUSIONE-HS-2 - Manual (Page 66)

Chapter 4: System Setup and Wiring
4.10.2 Controller Unit DIP Switch positions 4 ~ 8
DIP switch positions 4 ~ 8 are used for setting the
described in the following table.
from multiple spindles whereas the data needs to be identified differently between each spi
dle. Do not set two spindles with the same address.
Note: The Controller unit must be powered off a
to be initialized
Unit
No.
DIP SWITCH NUMBER
4 5 6 7
1 OFF OFF OFF OFF
2 OFF OFF OFF ON
3 OFF OFF OFF ON
4 OFF OFF ON OFF
5 OFF OFF ON OFF
6 OFF OFF ON ON
7 OFF OFF ON ON
8 OFF ON OFF OFF
9 OFF ON OFF OFF
10 OFF ON OFF ON
11 OFF ON OFF ON
12 OFF ON ON OFF
13 OFF ON ON OFF
14 OFF ON ON ON
15 OFF ON ON ON
Page 4-28
4.10.2 Controller Unit DIP Switch positions 4 ~ 8
DIP switch positions 4 ~ 8 are used for setting the Controller unit spindle address number as
described in the following table. This can be beneficial if fastening data is being collected
from multiple spindles whereas the data needs to be identified differently between each spi
Do not set two spindles with the same address.
unit must be powered off and on again for the DIP switch changes
DIP SWITCH NUMBER
Unit
No.
DIP SWITCH NUMBER
8 4 5 6 7 8
OFF ON 16 ON OFF OFF OFF OFF
ON OFF 17 ON OFF OFF OFF ON
ON ON 18 ON OFF OFF ON OFF
OFF OFF 19 ON OFF OFF ON ON
OFF ON 20 ON OFF ON OFF OFF
ON OFF 21 ON OFF ON OFF ON
ON ON 22 ON OFF ON ON OFF
OFF OFF 23 ON OFF ON ON ON
OFF ON 24 ON ON OFF OFF OFF
ON OFF 25 ON ON OFF OFF ON
ON ON 26 ON ON OFF ON OFF
OFF OFF 27 ON ON OFF ON ON
OFF ON 28 ON ON ON OFF OFF
ON OFF 29 ON ON ON OFF ON
ON ON 30 ON ON ON ON OFF
31 ON ON ON ON ON
unit spindle address number as
This can be beneficial if fastening data is being collected
from multiple spindles whereas the data needs to be identified differently between each spin-
nd on again for the DIP switch changes
8
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON