FEC FUSIONE-HS-2 - Manual (Page 18)

Chapter 1: Outline
Page 1-4
• Motor
A permanent magnet High Speed DC motor provides for improved fastening control.
The sealed design of the motor provides greater protection from contamination without
generating excess heat. The resolver is uniquely designed to withstand harsh
environments and provide high resolution control / angular feedback signals.
• Preamplifier
Quality control of the tool torque transducer is accomplished electronically (digitally)
through the EEPROM (Electrically Erasable Programmable Read Only Memory) in the
preamplifier. During factory setup of the torque transducer, the unit is Dead Weight and
Dynamically tested against Standards that are certified and traceable to the National
Institute of Standards and Technology. The resultant data is then programmed into the
preamplifier where it is stored on non-volatile EEPROM. The preamplifier also contains
the “Smart Tool ID” system which allows automatic tool recognition and protects against
misapplication of tools onto the wrong controller or set-up.
• Servo Amplifier (Servo Drive)
Reduced equipment size with improved drive circuit strength is the result of
incorporating Isolated Gate Bipolar Transistor (IGBT) technology into the drive System.
• Plug-In Firmware Update System
The CONTROLLER Firmware is stored in Flash ROM and can be rewritten with future
Firmware updates via a plug-in connector located on each unit. There is no need to
remove the unit or disassemble the unit for any Firmware upgrades.
• Motor, Resolver and Transducer Combined Cable
A single high flex cable incorporates durable metal connectors to provide for extended
life in harsh environments. Twist lock connectors provide easy separation of
connection points for maintenance, while maintaining superior contact under operating
conditions. Separate tool and extension cables (Straight and 90 Degree) are available
for improved cable management.
• ToolsNet / Network Connectivity
Optional Ethernet connectivity (10/100BaseT) available for export of fastening data or
connection to existing Atlas Copco ToolsNet network via the Open Protocol for
ToolsNet.