Technicolor - Thomson ST585 V6 - Manual (Page 805)

E-DOC-CTC-20061027-0004 v1.0
System Logging Messages
781
RIP Module
Facility Severity Contents
LOCAL1 INFO RIP Packet received from unknown interface
LOCAL1 INFO RIP Packet size is smaller than minimum size
LOCAL1 INFO RIP Packet size is greater than maximum size
LOCAL1 INFO RIP Wrong RIP packet alignment
LOCAL1 INFO RIP RIP version 0 with command received
LOCAL1 INFO RIP Reserved field not zero in RIP header
LOCAL1 INFO RIP RIP is not enabled for network address
LOCAL1 INFO RIP Packet's v does not match to RIP v
LOCAL1 INFO RIP Packet's v does not match to RIP v on interface
LOCAL1 INFO RIP Packet v is dropped because authentication is disabled on
interface
LOCAL1 INFO RIP Simple password authentication failed on interface
LOCAL1 INFO RIP No authentication in RIP packet
LOCAL1 INFO RIP Obsolete command received
LOCAL1 INFO RIP Unknown RIP command received
LOCAL1 INFO RIP Response does not come from default RIP port
LOCAL1 INFO RIP Datagram doesn't come from a valid neighbor:
LOCAL1 INFO RIP Unsupported family from
LOCAL1 INFO RIP Network is net 127, class D or class E network
LOCAL1 INFO RIP Address is my own address, net 0 or not unicast
LOCAL1 INFO RIP RIPv1 packet with incorrect must be zero fields
LOCAL1 INFO RIP Route metric is not in the 1-16 range
LOCAL1 INFO RIP Nexthop address is not directly reachable
LOCAL1 INFO RIP RIPv2 address is not correct mask / applied
LOCAL1 INFO RIP Not configured for sending RIPv1 packet on interface
LOCAL1 INFO RIP RIP routing table is full
LOCAL1 INFO RIP Neighbor is not connected to direct network
LOCAL1 INFO RIP Interface has not any valid local IP address for sending RIPv2
packets
LOCAL1 INFO RIP Interface has not any valid %s address for sending
RIPv packets