Technicolor - Thomson ST585 V6 - Manual (Page 519)

E-DOC-CTC-20061027-0004 v1.0
Label Commands
495
label rule add
Add a label rule.
SYNTAX:
where:
label rule add chain =
[index = ]
[name = ]
[clink = ]
[srcintf [!]= ]
[srcip [!]= <{ip address | private}>]
[dstip [!]= <{ip address | private}>]
[serv [!]= <{service name}>]
[log = <{disabled | enabled}>]
[state = <{disabled | enabled}>]
label =
i
If a value is preceded by a “!”, it means NOT.
For example “srcintf=!wan” means “if srcintf is different from WAN”.
chain The name of the chain in which the rule must be inserted. REQUIRED
index The index number of the rule before which the new rule must
be added.
Tip Use the command :label rule list to obtain the
index number of the applicable rule.
OPTIONAL
name The name of the new rule. OPTIONAL
clink The name of the chain to be parsed when this rule applies. OPTIONAL
srcintf The name of the source interface expression. OPTIONAL
srcip The name of the source IP expression. OPTIONAL
dstip The name of the destination IP expression. OPTIONAL
serv The name of the service expression. OPTIONAL
log Disable or enable logging when this rule applies.
The default is
disabled .
OPTIONAL
state Disable or enable this rule.
The default is
enabled .
OPTIONAL
label Choose between:
> None
> link (when clink is used)
> label name.
REQUIRED