Technicolor - Thomson ST585 V6 - Manual (Page 596)

E-DOC-CTC-20061027-0004 v1.0
NAT Commands
572
nat tmpladd
Add an address mapping template.
SYNTAX:
where:
nat tmpladd [intf = ]
[group = <{wan|local|lan|tunnel|dmz|guest} or
number>]
[timeout = ]
[type = <{napt | nat}>]
outside_addr =
[inside_addr = ]
[access_list = ]
[foreign_addr = ]
[protocol = <{supported IP protocol} or number>]
[outside_port = ]
[inside_port = ]
[mode = <{auto | inbound | outbound}>]
intf The IP interface name. OPTIONAL
group The IP interface group scope for this template.
Choose between:
>
wan
>
local
> lan
> tunnel
> dmz
> guest.
Note If an interface has been defined with the parameter intf ,
then the setting for this parameter is ignored.
OPTIONAL
timeout A number between 0 and 6553 (seconds).
Represents the lifetime for this template. OPTIONAL
type The type of NAT map to be used.
Choose between:
>
napt : The map is a NAPT map or a port-shifting NAT map.
>
nat : The map is a basic NAT map or a two-way NAT map.
OPTIONAL