Service system modify, Modify a system service, Service commands – Technicolor - Thomson ST585 V6 User Manual
Page 665: Syntax, Related commands
E-DOC-CTC-20061027-0004 v1.0
Service Commands
641
service system modify
Modify a system service.
SYNTAX:
where:
RELATED COMMANDS:
service system modify
name =
[state = <{disabled | enabled}>]
[port =
[srcintf =
[log = <{disabled|enabled}>]
[qoslabel = <{None|DSCP|Interactive|
Management|Video|VoIP|default}>]
[routelabel = <{None|DSCP|Interactive|
Management|Video|VoIP|default}>]
[natpmweight =
[forward = <{disabled|enabled}>]
name
The name of the system service for this map.
REQUIRED
state
Disable or enable this system service.
OPTIONAL
port
The port for this map.
Select one of the supported TCP/UDP port names (see
“ Supported TCP/UDP Port Names” on page 787
) or,
alternatively, specify the port number.
OPTIONAL
srcintf
The primary IP interface for this system service.
OPTIONAL
log
Disable or enable service logging
OPTIONAL
qoslabel
QoS label for service data
OPTIONAL
routelabel
Route label for service data
OPTIONAL
natpmweight
NAT portmap weight for this service
OPTIONAL
forward
Disable or enable service forwarding
OPTIONAL