Technicolor - Thomson ST585 V6 - Manual (Page 740)

E-DOC-CTC-20061027-0004 v1.0
UPnP Commands
716
upnp config
Configure the UPnP™ parameter(s).
SYNTAX:
where:
upnp config [maxage = ]
[writemode = <{full | natonly | readonly}>]
[safenat = <{disabled | enabled}>]
[preferredaddress = ]
[httpport = ]
maxage A number between 60 and 999999.
This parameter allows to configure how often the Thomson ST
sends a notification message to advertise its presence as an
Internet Gateway Device (IGD) on the network.
The default is
1800 .
Note Setting this parameter to a low value will increase the
number of packets sent over time on the network, but will
make the state of the device more up to date.
OPTIONAL
writemode Choose the set of rules to limit remote access from UPnP.
Choose between:
>
full : the host will accept all the UPnP SET and GET actions.
>
natonly : GET and NAT related SET actions will be accepted, all
other actions will be ignored.
>
readonly : the UPnP control point will only be able to retrieve
information, all the SET actions are ignored.
The default is natonly .
OPTIONAL
safenat Enable or disable check on safe NAT entries.
If this check is enabled, all NAT create/delete requests for a LAN
side IP address different from the source IP address of the UPnP
message will be discarded.
The default is
enabled .
OPTIONAL
preferredaddress CSV list of preferred IP address for UPnP advertisements (1 per
LAN IP interface).
Note Enter “0.0.0.0” for none.
OPTIONAL
httpport A number between 1 and 65535.
Represents the web server port.
The default is
80 .
OPTIONAL