Technicolor - Thomson ST585 V6 - Manual (Page 127)

E-DOC-CTC-20061027-0004 v1.0
CWMP Commands
103
EXAMPLE:
maxEnvelopes Set the maximum number of SOAP envelopes sent
within one HTTP message.
The default is
2 .
OPTIONAL
connectionRequest Set the connection request flag of the cwmp daemon.
Choose between:
> enabled
> disabled.
The default is enabled .
OPTIONAL
connectionReqPath Set the path where the cwmp daemon can be reached. OPTIONAL
connectionReqUserName Set the username the ACS must use to log in. OPTIONAL
connectionReqPsswd Set the password the ACS must use to log in. OPTIONAL
connectionReqAuth Set the digest authentication flag of the cwmp
daemon.
Choose between:
> enabled
> disabled.
The default is enabled .
OPTIONAL
qos-class Set the quality of service class for outgoing CWMP
data.
The default is
12 .
OPTIONAL
bootdelayrange Set the delay on boot (in seconds) before inform is
sent.
The default is
0 .
OPTIONAL
=>cwmp config
State
: disabled
Mode : readonly
Max Envelopes : 2
Session Timeout : 60
No Ip Timeout : 10
Connection Request Port : 80
Periodic Inform : enabled
Periodic Inform Interval : 20000 ms
Connection Request : enabled
Connection Request UserName :
Connection Request PassWord :
Connection Request Path :
Connection Request Authentication : enabled
Qos class
: 12
Boot delay range between 0 and : 0s
=>