Technicolor - Thomson ST585 V6 - Manual (Page 457)

E-DOC-CTC-20061027-0004 v1.0
IP Commands
433
EXAMPLE:
addrcheck Set the level of IP address checks.
Choose between:
> off : No address checking is performed. For advanced
users only; in normal circumstances there should always
be some kind of address checking.
>
own : Minimum level of checking.
Only the address configuration on the Thomson ST is
checked.
> static : Checking of the address configuration of the
Thomson ST and also of traffic: addresses of incoming
packets; this checking is related to constants (for
example an address may not be entirely composed of
one‘s or zero‘s).
> dynamic : Besides the address configuration of the
Thomson ST itself, and besides the checking of traffic on
a constants level, additional checking is performed on
the IP addresses that are determined by the
configuration, more specifically by the network.
The default is dynamic .
OPTIONAL
mssclamping Disable or enable mss clamping for low MTU interfaces.
Enabling mss clamping assures that the size of a TCP packet
never exceeds the available Maximum Transmission Unit
(MTU) of the outgoing interface.
The default is
on .
Note It is recommended not to disable this parameter.
OPTIONAL
natloopback Disable/Enable NAT loopback.
The default is
enabled .
OPTIONAL
loadbalancing Select loadbalancing mechanism OPTIONAL
bitrate-window(sec) A number between 10 and 3600.
Set the window to calculate the bitrate (multiple of 10).
The default is
30 .
OPTIONAL
acceleration Disable/Enable IP acceleration OPTIONAL
=>ip config
Forwarding enabled
Sendredirects enabled
IP options enabled
NetBroadcasts disabled
Default TTL 64
Fraglimit 64 fragments
Fragcount currently 0 fragments
Defragment mode : enabled
Address checks : dynamic
Mss Clamping : enabled
NAT Loopback : enabled
Bitrate window (sec), multiple of 10 : 30
=>