Wireless ifconfig, Configure the wireless settings, Wireless commands – Technicolor - Thomson ST585 V6 User Manual
Page 757: Syntax
E-DOC-CTC-20061027-0004 v1.0
Wireless Commands
733
wireless ifconfig
Configure the wireless settings.
SYNTAX:
where:
wireless ifconfig
[state = <{enabled | disabled}>]
[channel =
<{auto | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10
| 11 | 12 | 13}>]
[ssid =
[any = <{disabled | enabled}>]
[interop = <{802.11b | 802.11b/g | 802.11g}>]
[frameburst = <{disabled | enabled}>]
state
Enable or disable the interface operational status of wireless access
point.
The default is
enabled
.
OPTIONAL
channel
The communication channel number.
Choose between:
>
auto
: the best communication channel is automatically selected by
the Thomson ST (recommended setting).
>
a number between 1 and 14.
Note
Depending on local regulations, the number of channels
actually allowed to be used, may be restricted.
The default is
auto
.
OPTIONAL
ssid
The network name, also known as Service Set ID (SSID).
OPTIONAL
any
Make the SSID public or not.
Choose between:
>
enabled
: the Thomson ST broadcasts its SSID and accepts every
client.
>
disabled
: the Thomson ST does not broadcast its SSID and accepts
only those clients who have the correct SSID.
The default is
enabled
.
OPTIONAL
interop
Select the interoperability mode.
Choose between:
>
802.11b
: only IEEE 802.11b clients can connect to the Thomson ST.
>
802.11b/g
: IEEE 802.11g and b clients can connect to the
Thomson ST.
Note
When a IEEE 802.11b client connects to the Thomson ST,
the modulation rate drops to 11Mbps for this client.
>
802.11g
: only IEEE 802.11g clients can connect to the Thomson ST.
The default is
802.11b/g
.
OPTIONAL
frameburst
Enable or disable framebursting.
The default is
disabled
.
OPTIONAL