Technicolor - Thomson ST585 V6 - Manual (Page 41)

E-DOC-CTC-20061027-0004 v1.0
ATM Commands
17
3 ATM Commands
Introduction
This chapter describes the commands of the atm command group.
Contents
This chapter covers the following commands:
atm flush Flush all Asynchronous Transfer Mode (ATM) interfaces. 19
atm ifadd Create a new ATM interface. 20
atm ifattach Attach a ATM interface. 21
atm ifconfig Configure an ATM interface. 22
atm ifdelete Delete an ATM interface. 24
atm ifdetach Detach an ATM interface. 25
atm iflist Display the ATM interfaces. 26
atm bundle add Add a new bundle of interfaces. 27
atm bundle attach Attach a bundle of interfaces. 28
atm bundle config Modify a bundle of interfaces. 29
atm bundle clear Clear the bundle statistics. 30
atm bundle delete Delete a bundle of interfaces. 31
atm bundle detach Detach a bundle of interfaces. 32
atm bundle flush Flush all bundles. 33
atm bundle ifadd Add an interface on a bundle. 34
atm bundle ifconfig Configure an interface from a bundle. 35
atm bundle ifdelete Remove an interface from a bundle. 36
atm bundle list Display the current bundles. 37
atm cac config Configure the ATM connection admission control. 38
atm cac list Display all the CAC parameters. 39
atm cac overbooking Configure ATM overbooking parameters. 40
atm debug aal5stats Display ATM Adaptation Layer 5 (AAL5) port specific ATM statistics. 41
atm debug gstats Display ATM global statistics. 42
atm debug portstats Display port specific ATM statistics. 43
atm oam config Modify the ATM Operation and Maintenance (OAM) settings. 44
atm oam list Display the ATM OAM settings. 45
atm oam modify Modify the ATM OAM data blocking mode. 46
atm oam ping Send ATM loopback cells. 48
atm oam cc list Display Continuity Check (CC) configuration. 49
atm oam cc modify Modify CC on the connection. 50
atm oam cc send Send CC activate/deactivate to connection. 51