Technicolor - Thomson ST585 V6 - Manual (Page 405)

E-DOC-CTC-20061027-0004 v1.0
GRP Commands
381
grp rip show
Show the RIP settings and the routes in the RIP database.
SYNTAX:
EXAMPLE:
grp rip show
=>grp rip show
RIP routing protocol config dump
------------------------------------
RIP daemon is enabled
Global RIP queries received : 0
Global RIP route changes : 3
Default version : send rip_v2, receive rip_v2
Default redistribution metric is 1
Sending routing table updates every 30 seconds with +/-5%
Route timeout after 180 seconds
Route garbage collect after 120 seconds
Import of connected routes is enabled
Import of kernel routes is enabled
Import of static routes is enabled
Import of default kernel route is enabled
Import of default static route is enabled
Export of RIP routes is enabled
Export of default RIP route is enabled
Transmission of default RIP route is enabled
Intf Send Recv AuthMode Passive SplitHorizon BadPackets BadRoutes SentUpd
ates
---------------------------------------------------------------------------------------------
----
eth0 rip_unspec rip_unspec none off on 0 58
62
RIP route table dump
----------------------
Codes : K - Kernel, C - connected, S - Static, R - RIP, * - FIB route
Network Next Hop Metric From Flags
---------------------------------------------------------------------
R 0.0.0.0/0
192.6.11.150 3 192.6.11.150 <> *
C 10.0.0.0/8 1 <> *
K 129.132.2.21/32 138.203.7.146 1 <> *
C 138.203.4.0/22 1 <> *
C 172.16.1.0/24 1 <> *
=>