Ip rtadd, Add a route to the routing table, Ip rtdelete – Technicolor - Thomson ST585 V6 User Manual
Page 475: Ip commands, Syntax
E-DOC-CTC-20061027-0004 v1.0
IP Commands
451
ip rtadd
Add a route to the routing table.
SYNTAX:
where:
ip rtadd
dst =
[dstmsk =
[label =
[gateway =
[intf =
[srcintf =
[metric =
dst
The destination IP address(es) for this route.
Note
Supports ip/mask notation.
REQUIRED
dstmsk
The destination IP address mask.
OPTIONAL
label
The name of the label.
OPTIONAL
gateway
The IP address of the next hop (direct connected gateway or extended
route).
Note
The parameters
gateway
and
intf
are mutually exclusive.
OPTIONAL
intf
Only for special interface routes: the outgoing IP interface name.
Note
The parameters
gateway
and
intf
are mutually exclusive.
OPTIONAL
srcintf
Use this interface for source address selection.
OPTIONAL
metric
The metric for this route (weight factor).
The lower the metric, the higher the weight.
The default is
0
.
OPTIONAL